Application : Mixers of this series are widely employed in plastic , rubber, pharmaceutical ,dyestuff ,foodstuff and daily chemical industries to mix ,agitate ,dry and color up all kinds of materials ,with the heating and cooling modes.

Features:
1, made of stainless steel in contact with the material, polishing of the inner surface, with good self-cleaning, dust proof seal. With liquid fillings and artificial fillings, easy to connect.
2, two sets of independent custom bearings are supported on the upper and lower sides of the pulley, eliminating the bending of the shaft under the tension of the belt. The bearings are lubricated with grease.
3, large size discharge disk, the inner surface of the release speed shutter plug and the inner wall of the container are in strict agreement, there is a complete mixture dead zone, using cylinder drive, flexible and reliable. Double side seal, no side leakage, hinge design, can be fully opened, easy to clean thoroughly.
4, to monitor the material temperature in real time, the probe with a wear-resistant coating, long service life, PTFE sheath for installation and insulation of the wall. Two thermal resistors, one to control and one to overheat.
5, 3 or 4 or stainless steel 304 casting. The best Eddy current can be obtained in the no-dead zone of the material during mixing. The spacing can be adjusted to replace the worn blades in a single piece. The surface has a wear-resistant coating that makes the life long.

Principle:
The machine uses four stirring motors to stir from the bottom and side of the drum at the same time, so that the raw material can be fully mixed and displayed. It is an ideal production equipment for high-end powder cake, blush, and eye shadow semi-finished material. The entire machine is made of stainless steel SUS304 materials; The atomizing effect of the oil injection is better because of the electric mixture. The vertical fuselage makes the area of the machine less.